C
Crazy Banjo
Guest
Yesterday I polished my brothers car with a compound and then Polish with Sealant. I finished with a layer of EX. However, it was very difficult - almost impossible - to put an even layer of EX on the car. I am not sure, but it seemed like the oil in the EX vaporised far too quickly.
It was quite strange. When I applied it, I could see large spots with no visible layer of EX - even though I knew I had covered the area - and spots with what seemed as too much EX. Besides, when I buffed the car a few hours later, the result was not as smooth and slick as it was when I had put on the layer of Polish with Sealant.
I didn't do the job in direct sunlight, and it was about 20 degrees Celsius. I applied the EX by hand.
What are your thoughts about this? What do you think happened?
It was quite strange. When I applied it, I could see large spots with no visible layer of EX - even though I knew I had covered the area - and spots with what seemed as too much EX. Besides, when I buffed the car a few hours later, the result was not as smooth and slick as it was when I had put on the layer of Polish with Sealant.
I didn't do the job in direct sunlight, and it was about 20 degrees Celsius. I applied the EX by hand.
What are your thoughts about this? What do you think happened?