NEED A LITTLE HELP

[REELKNOT]

I JUST BOUGHT THE PC7424 BUT HAVE USED CHEAPER ORBITAL BUFFERS PRIOR.I HAVE A 2007 TITAN SMOKE IN COLOR.I AM LOOKING FOR A GOOD CAR WASH AND CLAY BAR-I HAVE VERY FINE SWIRL MARKS THAT YOU CAN SEE ON AN ANGLE WHEN PARKED NEAR A STREET LIGHT BUT REALLY DONOT NOTICE THEM IN THE BRIGHT SUN-I WOULD LIKE TO REMOVE THEM AND THEN PUT ON A GOOD WAX-ALL WITH THE PC-WHAT SHOULD I USE?

 

[BigLeegr]

What pads do you have? Are you looking to polish the swirls out or just fill with a glaze?

 

[REELKNOT]

I HAVE 6.5 IN CCS PADS-2 WHITE,1 GRAY,1 BLUE

 

[REELKNOT]

WOULD LIKE TO POLISH THEM OUT-IS A GLAZE THE SAME AS A SEALANT OR A POLISH(CHEMICAL POLISH)

 

[BigLeegr]

A glaze "fills" light marring. It wears off and the marring is again visable. Sometimes this is the best answer if your paint is old/thin (not likely in your case, of course) or if the person just wants to do a "quick fix." The glaze needs to be topped with a wax.

To see what you need to do to polish out your swirls, I'd say read the posts throughout this forum. There are many threads with the same type of question as yours, with much more info than I'd likely type out.